Altenew | Dimensional Cape Marguerite Flowers Card

Hi friends!

I’m sharing today a dimensional floral card featuring the floral beauty of the Craft-A-Flower: Cape Marguerite Die Set, complemented by a textured background achieved using a Hosta 3D Embossing Folder.

CRAFT-A-FLOWER: CAPE MARGUERITE DIE SET

I started off by creating the layered die-cut flowers using the Craft-A-Flower: Cape Marguerite Die Set, New Purple, and Green Meadows Gradient Cardstock Sets.

After die-cutting all the layers, I assembled the flowers by stacking and adhering the corresponding layers.

Additionally, I added some shading to the floral elements using Woodless Pencils. To be honest, I made this decision after already assembling the flowers just because I wanted to add more interest to them. And, of course, I didn’t want to disassemble them or start over to add coloring. Opting for Woodless Pencils as a coloring medium was the best choice in this case.

I used a relatively small Artists’ Watercolor Brush #1 to color. I had it slightly wet, picked up pigment from a pencil and added it to flower petals and leaves.

The Lavender Fields and Ultramarine pencils were used to color the flowers, and Shadow Creek pencil was used to color the leaves.

The gradient cardstock itself is not meant for coloring and wetting; it could flatten the embossing of the die-cut elements which dies of the Craft-A-Flower: Cape Marguerite Die Set created. So using as less water as possible was the key. I made sure my brush almost dry, just wet enough to pick up pigment from pencils.

HOSTA 3D EMBOSSING FOLDER

After creating the floral elements, I moved on to creating the background. First, I embossed a Solar White Cardstock panel using the Hosta 3D Embossing Folder. Next, I tore its top edge to add some interest to it.

I adhered the die-cut elements onto the panel, forming the floral cluster. I followed by adding tiny purple splatters onto the floral grouping and background. I used a wet brush and Lavender Fields Woodless Pencil to create splatters.

The panel was foam-mounted onto a purple card base using black foam tape.

I used the Thank You Builder Stamp Set and Ultraviolet Fresh Dye Ink to make the sentiment label. The sentiment was stamped onto a Solar White Cardstock stripe and popped onto the card, finishing it off.

SUPPLIES

If you’re curious about the supplies I used, you can find everything listed below.

Some of the links are affiliate links, which means I may earn a small commission if you shop through them — at no extra cost to you.

You can use the letter codes to shop from your favorite stores: Simon Says Stamp (SSS), Altenew (AN), Scrapbook.com (SC), Amazon (AZ), Spellbinders (SB), Papertrey Ink (PTI), and more.

I really appreciate your support 🤍

Altenew Thank You Builder Stamp Set Click A Shop: AN	Altenew Craft-A-Flower: Cape Marguerite Click A Shop: AN	Altenew Ultraviolet Fresh Dye Ink Click A Shop: AN	Altenew Gradient Cardstock Set – Green Meadows Click A Shop: AN	Altenew Gradient Cardstock Set – New Purple Click A Shop: AN
Altenew Hosta 3D Embossing Folder Click A Shop: AN	Altenew Instant Dimension Foam Tape Click A Shop: SSS | AN	Altenew Woodless Watercolor Pencil 24 Set Click A Shop: AN	Altenew Artists Watercolor Brushes – Round Click A Shop: AN